Carver Mariner 28 Enthusiasts Forum
Carver Mariner 28 Enthusiasts Forum
Home | Profile | Register | Active Topics | Active Polls | Members | Private Messages | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?





 All Forums
 Carver Mariner 28 foot forum
 Carver Mariner 28 forum
 Exhaust manifolds		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Bob On This


USA
175 Posts
Posted - 08/09/2009 :  7:31:10 PM  Show Profile Send Bob On This a Private Message  Reply with Quote
Removed and disassemble the exhaust manifolds on the Crusaders today.
The gasket seems to block all but the top water port on both the riser and the elbow.
Does anyone know if this is standard?
Does leaving the top port open allow the water to stay in the manifold longer and keep the flow down?

Bob

Diver Down

Bob On This



USA
175 Posts
Posted - 08/11/2009 :  11:14:40 AM  Show Profile Send Bob On This a Private Message  Reply with Quote
Found some info on another site.

Three hole gasket, tabs up, go between the manifold and the riser, and a single hole, hole up, goes between the riser and the exhaust outlet.

This keeps the exhaust full of water.

Bob

Diver Down
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Carver Mariner 28 Enthusiasts Forum © 2000-2005 ForumCo.com - The Forum Company Go To Top Of Page
This page was generated in 0.06 seconds. Powered By: Snitz Forums 2000 Version 3.4.05
RSS Feed 1 RSS Feed 2
Powered by ForumCo 2000-2008
TOS - AUP - URA
ForumCo Free Blogs and Galleries
Signup for a free forum or Go Banner Free