Carver Mariner 28 Enthusiasts Forum
Carver Mariner 28 Enthusiasts Forum
Home | Profile | Register | Active Topics | Active Polls | Members | Private Messages | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?





 All Forums
 Carver Mariner 28 foot forum
 Carver Mariner 28 forum
 Flo-Scan Fuel Flow Meters
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

MizunkY


53 Posts

Posted - 09/17/2009 :  10:04:11 AM  Show Profile Send MizunkY a Private Message  Reply with Quote
Has anyone used a fuel flow meter or are at least familiar with them? They seem like the most worthwhile investment to-date. According to the reviews, they are spot on accurate. I wonder what it would cost to have one of these installed, for twin engine of course.

Bob On This



USA
174 Posts

Posted - 09/17/2009 :  12:16:09 PM  Show Profile Send Bob On This a Private Message  Reply with Quote
My Carver came with one (I think it was added by the PO).
There are two sending units, one on each fuel filter inlet, and they are wired together.
I have not run the boat yet, but I think I get one reading, the combined flow from both engines.

There is a totalizer as well, with a reset switch.

If I had to do it over again, I would get one that interfaces with a GPS, or paddle wheel, that would then do the math for me, and actually show MPG.

Diver Down
Go to Top of Page

Jimbo Song



236 Posts

Posted - 09/17/2009 :  3:32:18 PM  Show Profile Send Jimbo Song a Private Message  Reply with Quote
Dual gauge kit with totalizer will cost you $350 to $400 depending on your engine application. Plus you will most likely need a surge protector for each fuel pump.

I strongly recommend calling FloScan and talking directly to them so they can advise you exactly what you need.

Pricey but well worth the money. Can pay for themselves easily in one year with fuel efficiency and svaings.

Bob


1987 Carver Voyager 28
"Jimbo Song"
Palm Coast, FL
Go to Top of Page

Rockmeister



USA
307 Posts

Posted - 09/20/2009 :  08:49:45 AM  Show Profile Send Rockmeister a Private Message  Reply with Quote
Lowrance makes a NMEA2000 unit called a MFD Multifunction Display.
I have a LMF-400 it does the MPG calculation for you using a paddle wheel.
Shows water speed also.
Also have it connected to my trim tabs also showing current tab positions.

Pretty handy!
It is a fully Plug & Play set-up, very easy to install.

If you hunt around, you can get the whole set-up(Including sensors, cables, etc) for less than the price of the Flowscans.

Obtained the MFD itself from Cabelas, the sensors I got from a place on the east coast, will have to look it up.

Can also add Fuel level sensors to it also, haven't gotten around to that one yet... lol

79 28' Mariner twin inboard V-drive.
Western Lake Erie: Maumee Bay & The Islands
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Carver Mariner 28 Enthusiasts Forum © 2000-2005 ForumCo.com - The Forum Company Go To Top Of Page
This page was generated in 0.09 seconds. Powered By: Snitz Forums 2000 Version 3.4.05
RSS Feed 1 RSS Feed 2
Powered by ForumCo 2000-2008
TOS - AUP - URA
ForumCo Free Blogs and Galleries
Signup for a free forum or Go Banner Free